Raymond mill maintenance criterion of seven | Forum

Topic location: Forum home » General » General Palooza Topics
xuanxuan Apr 17

Raymond mill is also called Raymond mill, because of Raymond mill stable performance, strong adaptability and high cost performance, since the introduction of more than 20 years in our country, has been popular used in the processing of non-metallic minerals. To make the Raymond mill is normal, should be developed equipment "equipment maintenance security operating system" in order to ensure the safe operation of the mill for a long time, at the same time...

Raymond mill is also called Raymond Mill, because of Raymond mill stable performance, strong adaptability and high cost performance, since the introduction of more than 20 years in our country, has been popular used in the processing of non-metallic minerals. To make the Raymond mill is normal, should be developed equipment & other; Equipment maintenance safety operation system & throughout; In order to ensure the safe operation of the mill for a long time, at the same time it is necessary to learn some Raymond mill keeping maintenance of common sense, when encounter problems can also be processed in a timely manner.

1, Raymond mill, in use process, should be fixed personnel responsible for the supervision, the operator must have a certain technical level. Mill before installation must make the necessary technical training to operators, to understand the principle of Raymond mill performance, familiar with the operation procedures.

2, to make the grinding machine is normal, should be developed equipment & other; Equipment maintenance safety operation system & throughout; To ensure the safe operation of the mill for a long time, at the same time to have the necessary maintenance tools as well as grease and the corresponding accessories.

3, SBM Raymond Mill machine use after a period of time, should be for maintenance, as well as the roller shovel knife of ring replacement/repair parts processing, such as roller device is in use for connecting bolt and nut should be examined before and after, to see whether there is loose phenomenon, lubricating oils are added.

4, roller device used for more than 500 hours to replace the roller, the roller set inside of the rolling bearing must be clean, the damaged parts should be replaced in a timely manner, refueling tools available manual pumps and grease gun.

5, fineness regulation, according to the size of the material, hardness and softness, water content, specific gravity, processing the thickness is different, can be adjusted at the top of the analyzer, high speed, high fineness, low speed, low fineness.

Improve fineness, production will be reduced, if still can not meet the requirements should debug fan speed, when the user can be flexible.

6, the abandonment of roller grinding ring limit and minimum residual wall thickness shall not be less than 10 mm.

Parking is 7, Raymond mill, first stop feeding, the host continued to expect them and make the residual abrasive continue grinding, about a minute later, can shut down a host motor and analyzer machine, stop the grinding work, later to stop the fan motor, so that net residual powder.